Made in the UK.

Temperature to +1000º C.
These units can operate in high temperatures, (up to 1000º C) dependant on selection of bush material. Our sales team (Contacts) will be pleased to advise

Applications
In Water, Steam, Chemicals, Hostile environments etc. Our sales team (Contacts) will be pleased to advise.

Housing in various materials.
Standard bearing housings are made in grey cast iron but can be supplied in any available material i.e.: - Stainless steel, bronze etc.

Self-Aligning
Precise positioning and accurate alignment during installation are unnecessary

Housing (Protection).
Standard bearing housings are made in grey cast iron but can be plated (chrome, nickel, zinc etc) as required.

Bush Material
Various bush materials can be used depending on the application and our sales team will be pleased to advise

High Performance -
Excellent load carrying capacity eliminates edge loading

Long Life
Long life with minimum maintenance. Sealing is unnecessary in most applications.

Easy Assembly
Working clearance of bearings on shaft eliminates press fitting needed with some rolling element bearings

Availability
A wide range of standard stock sizes is offered

Shaft Location
A shaft collar or shoulder can provide axial location where necessary

Standard Range
Three types - Plummer (or pillow) block, Four bolt flange mounting. Two bolt flange mounting.

Stock
Metric and Inch ranges are available on a very short delivery (dependant on selection) for shaft diameters from 10mm to 150mm (1/2" to 6").

Selection
If you have experience of any proprietary material you would like to use we will be pleased to quote or our sales staff (contacts) will be pleased to advice you if you are unsure of the best materials for your application.

Housing Loads
The maximum permissible loading for the bush. Particularly at low rubbing speeds, may exceed that for the housing, Where such conditions are likely to occur, design advice should be obtained

*EXALIGN is a registered trade mark of Criptic Arvis Ltd